The Function Generator is a useful test instrument capable of generating multiple waveforms like sine, square and triangle at any required frequency, in switched decade sub-ranges. The generator has an output BNC connector, 50 ohms output impedance and a maximum wave output of 10 volts peak to peak, which may be adjusted by a variable potentiometer control. The 50 ohms output has a DC level shift control, which can affect a ± 5 volt level shift. The Function Generator has a function selection switch; sine, square, triangle or TTL is selectable by a switch. The frequency of the signal is displayed accurately on a six-digit auto ranging frequency counter.

The model provides an ideal signal source for testing of servo and vibrating systems, medical and geophysical equipment, audio amplifiers, transducer circuits, filter circuits etc. The Function Generator uses high performance low drift circuitry to ensure low distortion and frequency stability. The entire circuit is laid on high quality printed circuit board, which is epoxy masked and component numbers are marked on it, for easy maintenance and servicing.

TECHNICAL SPECIFICATIONS

Frequency Range	1Hz to 100KHz (sine output usable up to 1MHz) in seven decade ranges (0.1 to 1Hz, 1Hz to 10Hz, 10Hz to 100Hz, 100Hz to 1KHz, 1KHz to 10KHz, 10KHz to 100KHz, 100KHz to 1MHz)
Waveform selectable	Sine, Square, Triangle, TTL
Waveform Amplitude	0 - 10V peak to peak variable (50 ohms output)
Waveform Offset	+ 5V to - 5V on 50 ohms output
Output Impedance	50 Ohms (+ - 5%)
Accuracy	± 0.2% of reading ± 2 digit
Power Supply	220 volts / 50 Hz; +-10%
Accessory	Operating Manual and test lead